Duerkopp Adler HP Series Additional guide Manuál s instrukcemi stáhnout pdf (Strana 6)

EFKA AB220A5111

Explanation of letter symbols of the previous page and chapter ”Timing Diagrams“

Outputs:

FL = Sewing foot lifting FL1 = Sewing foot lifting without pulsing

VR = Backtacking STV = Stitch condensing

FA = Thread trimmer FA1 = Thread trimmer pos. 1...1A

FA2 = Thread trimmer pos. 1A...2 FA1+2 = Thread trimmer pos. 1...2

FA-V = Thread trimmer forward FA-R = Thread trimmer backward

FAU = Bobbin thread trimmer FAO = Needle thread trimmer

FSPL = Thread tension release AH = Tape cutter

FW = Thread wiper AH1/AH2 = Fast scissors

ML/NK = Machine running / Needle cooling KS = Chain suction

RB = Chain blowing in opposite direction STB = Blow fabric onto stack

KB = Chain blowing KS+KB = Chain suction + blowing

MST = Machine at standstill HP/FF1 = High lift for walking foot /

PD≥1 = Pedal steps 1...12 flip-flop 1

PD=0 = Pedal step 0 PD≤-1 = Pedal steps –1 / -2

L-STL = Indicator lamp for stitch length PD-2 = Pedal step -2

FZ = Thread puller DR-UK = Reversal of motor direction

IMP = Impulse STS = Stitch lock

LFA = Top cover thread cutter BR = Hot thread chain cutting

2 Putting into Service

Before putting the control into service, the following must be ensured, checked and/or adjusted:

§ The correct installation of the drive, position transmitter and accompanying devices, if necessary

§ The correct selection of the trimming operation by means of parameter 290

§ If necessary, the correct adjustment of the direction of motor rotation by means of parameter 161

§ The correct selection of the functions of keys (inputs) by means of parameters 240...249

§ The setting of the transmission ratio between motor shaft and machine shaft by means of parameter 272

§ The setting of the type of position sensor by means of parameter 270

§ If necessary, the setting of the number of angular degrees after the sensor position by means of parameter 271

§ If necessary, the setting of the positions by means of parameter 171

(possible with all settings of parameter 270)

§ The correct positioning speed by means of parameter 110

§ The correct maximum speed compatible with the sewing machine by means of parameter 111

§ The setting of the remaining relevant parameters

§ Start sewing in order to save the set values

See instruction manual for details!

1 2 3 4 5 6 7 8 9 10 11 ... 83 84

Žádné komentáře

Duerkopp Adler HP Series Additional guide Manuál s instrukcemi Strana 6