Duerkopp Adler FLP Series Additional guide Servisní příručka Strana 37

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 74
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 36
Operation
Operating manual 281 Version 06.0 - 05/2013 35
5.10 Setting the sewing foot pressure
The adjusting wheel (2) on the machine arm determines the
contact pressure of the sewing foot on the material to be sewn.
The pressure can be adjusted continuously by turning the wheel.
The adjusting mark (1) above the wheel indicates the pressure
selected.
Range for force setting: 10-80 N (10 N=1 kp)
Factory setting: 40 N (at 4800 st/min.)
Correct setting
The material being sewn does not slip and is correctly transported.
The correct pressure depends on the material to be sewn.
Faults due to incorrectly set sewing foot pressure
Excessively high pressure: Tearing of the material being
sewn
Excessively low pressure: Slipping of the material being
sewn
Figure 19: Setting the sewing foot pressure
Setting the sewing foot pressure:
1. Turn the adjusting wheel (2).
To increase the sewing foot pressure:
Turn the adjusting wheel (2) clockwise.
To reduce the sewing foot pressure:
Turn the adjusting wheel (2) counterclockwise.
(1) - Adjusting mark (2) - Adjusting wheel for the sewing
foot pressure
Zobrazit stránku 36
1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 73 74

Komentáře k této Příručce

Žádné komentáře